In this article
What makes outdoor TV installation different
A TV on a patio, lanai or pool deck lives in conditions no indoor install faces: sun heating the wall and the screen, wind-driven rain, humidity that condenses inside anything unsealed, and — near the coast — salt air that rusts ordinary steel in a single season. Mounting it the indoor way is how you end up with rust streaks down the stucco, a loose bracket and a TV that won't turn on after the first storm.
Our outdoor TV installation service plans for all of it: where the TV goes, what holds it up, how it gets power and how water is kept out of the wall and away from the connections.
Choosing the spot
The best position is under solid cover, out of direct afternoon sun and away from the line where rain blows in. Sun is the bigger enemy: it overheats the panel and washes out the picture. We look at the sun's path across the patio, where people actually sit — the lounge chairs, the outdoor kitchen, the pool — and the viewing distance.
A tilting mount angles the screen down and out of glare. A full-motion arm lets you turn the TV toward the pool in the afternoon and toward the dining table in the evening, and fold it flat against the wall when a storm is coming. Use the TV size calculator with your real seating distance — outdoor spaces tend to be bigger than they look.
Walls outside: stucco, block, brick and wood
Most outdoor walls are one of these:
- Stucco over concrete block (South Florida, Las Vegas): we drill through the stucco and anchor into the block with sleeve or wedge anchors.
- Stucco over wood framing (much of Southern California): we locate the studs behind the stucco and use lag bolts.
- Brick and stone columns and walls: masonry anchors into solid brick, never into mortar joints.
- Wood — pergola posts, beams and siding: lag bolts into solid framing, with a backer if the surface is thin.
Every hole gets exterior sealant before the bolt goes in, so water can't follow the anchor into the wall. Our guides on concrete and brick versus stone veneer explain the hardware.
Rather have a pro do it?
Send a request — we'll confirm the exact price and a time that suits you by text or call. 3-year warranty on every install.
Hardware that survives outside
Standard mounts are powder-coated steel with zinc bolts — fine indoors, not near a pool or the ocean. For outdoor installs we use weather-rated mounts and stainless or coated fasteners. If you've already bought a mount, we'll check it: a mount that's fine under a fully enclosed lanai may not be right for an open deck a mile from the beach.
Power and cables outdoors
Outdoor outlets must be GFCI-protected and should have an in-use cover that closes over a plugged-in cord. We check both. Cables run in outdoor-rated raceway or conduit, with a drip loop where they enter so water runs off instead of into the connection. Streaming devices get a spot out of the rain, and we test Wi-Fi strength at the TV before we leave — outdoor TVs are often at the edge of the router's range.
We don't install new outdoor outlets or circuits; if one is needed, we'll tell you exactly where it should go so an electrician can add it.
Outdoor TV installation in every region we serve
Outdoor TVs are a big part of our work in South Florida, where lanais and pool decks deal with humidity and salt — see outdoor TV installation in Miami. In Los Angeles, it's patios and covered decks with a lot of sun — see outdoor installs in LA. In Las Vegas the heat is the main concern, and in Dallas–Fort Worth it's covered patios and outdoor kitchens with brick and stone. Houston adds Gulf-coast humidity, San Diego salt air on every balcony, and in Atlanta and Chicago it's screened porches, decks and rooftop decks. In Charlotte and Raleigh–Durham it's screened porches through humid summers, and in Salt Lake City and Seattle covered patios have to handle snow and months of rain. Same prices, same-day slots and a 3-year warranty everywhere.
